Unknown what their ripple current rating is but since those are made for
audiophools Id give them a wide berth. The Dentron board is not drilled for
that lead pattern either which means a lot of drilling, jumpering and
securing.
Just get the full PS replacement kit from Harbach and do it right David or
I'll start calling you Dave (-;
Carl
KM1H
----- Original Message -----
From: <qrv@kd4e.com>
To: <amps@contesting.com>
Sent: Friday, February 14, 2014 9:48 PM
Subject: [Amps] 100+100uF 500VDC MLytic Dual High Voltage Capacitor?
Are these suitable for Ham amp power supplies?
http://www.soundlabsgroup.com.au/p/MU-MLYTIC-100-100-500V-Dual/100%2B100uF+500VDC+MLytic+Dual+High+Voltage+Capacitor
e.g. a Dentron Clipperton L which uses eight 100uF 500vdc
electrolytics.
--
David (NOT Dave) Colburn, KD4E - Nevils, Georgia USA
Safe & Secure Search Engine: duckduckgo.com
Android for Hams: groups.yahoo.com/group/hamdroid
Creative Tech: groups.yahoo.com/group/ham-macguyver
Raspi Alternative: groups.yahoo.com/group/beagleboneblack/
Restored to design-spec at Heaven's gate 1Cor15:22
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|