The 3CX800A7s shouldn't leak sitting on the shelf. Keep them stored away
from extreme temperatures (freezing and hot) and Rip Van Winkle tubes
should be ready to use after a 30-60 minute wait after turn on once they
are put back in use. This does allow for the getter to attach with stray
molecules once the filament heats up.
Have some NIB Eimac 3cx800a7's (YC-238) as spares for my Alpha amps.
Question is, should they be put in some kind of fixture and cooked with
air/filament v applied periodically to keep the boogymen away ? Is
filament and airflow all that is needed to periodically "condition" them?
Or is this all hogwash?
A fixture for these tubes is not needed. You can turn them on
periodically, as Carl suggested, and that is the best test.
If there is any way to preserve them in storage I'm game as they seem to
last forever if properly used - so a long time in storage is probable.
Do these external anode tubes tend to leak any more than other types ?
Not that I've heard of. Most of the similar sized (kW sized) triodes and
tetrodes from that company seem to have good brazed ceramic to metal
seals, in my experience. What bit of stray molecules remaining seem to
be adsorbed by getters when they are turned on. Its when they get
larger, like 200 kW and up, that the seals become very large diameter
and in multiple places, that the sources of leaks increases. In some of
these tubes such as RCA's 7835/4617 triode, warranty requires that they
be stored with external ion pumps energized at least every 60 days. Same
is true for a lot of the big CPI klystrons and those from other companies.
How does the "getter" work on these suckers (if any exists)? Do they need
to get equivalent to red hot like the 3-500z's to have the getter work?
Most certainly some type of getter, either a cold one or a heated one,
is used. Some tubes use the plate material as a getter, some use a
separate getter mounted near the filament connections, and some use a
small glass capsule getter that is broken open during sealing. The
application of flashed getter inside the envelope is not done in high
power ceramic metal tubes, for obvious reasons of contamination of the
insulation. Manufacturers are tight-lipped as to what they use in a
particular bottle, and usually its when they are broken open the
surprise is learned.
What has to be applied to keep them healthy ?
Anyone have a schematic for a burn in fixture?
If it were to be made, it would be a simple socket with blower/fan,
airflow interlock, filament power at a slightly low voltage with the
proper current limiting during turn on. More elaborate would be a tester
that applies plate voltage, and of course bias on the grid or cathode to
prevent excessively high beam current. As this is done, though, the
chances of the tube becoming an oscillator goes up, so 'stoppers' like
parasitic chokes and damping resistances would be considered. Its just
not worth the effort if you have the amplifier that can test them
occasionally.
73
John
K5PRO
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|