Which is available at Mouser.
73
Jim W7RY
-----Original Message-----
From: Tom WA9WSJ via Amps
Sent: Saturday, July 19, 2014 8:27 AM
To: amps@contesting.com ; mikflathead@aol.com
Subject: Re: [Amps] PC board spade terminals
Hi Mike,
Keystone electronics might have what you're after. Try this...
http://www.keyelco.com/category.cfm/250-6-35-Male-Tab-Quick-Fits/Vertical-Sturdi-Mount/p/401/id/877/c_id/1103
73
Tom
--------------------------------------------
On Sat, 7/19/14, mike via Amps <amps@contesting.com> wrote:
Subject: [Amps] PC board spade terminals
To: amps@contesting.com
Date: Saturday, July 19, 2014, 8:04 AM
I have a few Far Circuit high voltage
power supply boards. They have holes drilled for spade
terminals for the external connections. The problem is the
holes are drilled on 1/4 centers. All the connectors I see
on line are .200 centers. Does any one have a source for the
.250 center connectors. I am looking for 1/4 male spade.
Thanks Mike
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|