Re: [Amps] amp reading

[Roger D Johnson <n1rj@roadrunner.com>]

Small gauge teflon insulated wire.

73, Roger


On 1/23/2015 6:37 PM, Bill Turner wrote:
> ------------ ORIGINAL MESSAGE ------------(may be snipped)
>
> On Fri, 23 Jan 2015 23:17:00 +0000 (UTC), you wrote:
>
> > One of the things I wonder about is how you add a resistor to
> the filament lead since it seems it is going to have to be about
> 0.2/0.4 ohms or so at high current. Maybe a wire but that can add
> inductance so I was never clear on that. I suspect my Dentron could
> use that mod but I haven't done it yet.
> >   
> > Terry
> > KI7M
> REPLY:
>
> mouser.com has many such resistors available.
>
> Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps