I see. I didn't understand. I thought you meant ONLY 208 and 220.
My old QTH in Fresno was usually quite close to 240.
On 24 Jan 2015 18:44, Martin A Flynn wrote:
Vic
240 is the original operating voltage. Considering the cost of the
tube, I don't want to starve the filaments by operating at the lower
voltage.
Is there anywhere in the US that still has 120/240 volt power?
73, Martin
W2RWJ
On 1/24/2015 11:31 AM, Vic Rosenthal wrote:
But he should have them add a tap for 240, too.
Vic K2VCO /4X6GP
On Jan 24, 2015, at 5:56 PM, Jim W7RY <w7ry@centurytel.net> wrote:
Agreed!
73
Jim W7RY
-----Original Message----- From: Paul Kraemer Sent: Saturday, January
24, 2015 7:06 AM To: maflynn@theflynn.org ; amps@contesting.com
Subject: Re: [Amps] Vendor For Transformer Rewind
Martin
My vote goes hands down to the folks at Heyboer
Paul K0UYA
-----Original Message----- From: Martin A Flynn Sent: Saturday,
January 24, 2015 8:51 AM To: amps@contesting.com Subject: [Amps]
Vendor For Transformer Rewind
A while back I had picked up a Henry 3002A amplifier with a shorted
transformer. I am interested in locating a vendor to re-wind the
original (or supply a replacement) that will not require butchering
the chassis, along with adding taps on the primary for 208 and 220
(club station is 208, house is 220)
73 W2RWJ
Martin
--
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|