Use WWll metal 6AG7s and invert them in circulating water in an old aquarium
and driven by an aquarium pump. I read about this in CQ(?) during the 1950s.
I read it in the local library since I lacked funds to subscribe at age 12
Dave
W7VM
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Mike Waters
Sent: Friday, July 10, 2015 5:11 PM
To: amps@contesting.com
Subject: [Bulk] Re: [Amps] Super Cathode Driven 4CX250B
Hi Bill,
On Fri, Jul 10, 2015 at 2:03 PM, Fuqua, Bill L <wlfuqu00@uky.edu> wrote:
> Well, I am thinking about old projects I have not gotten back to. ...
> the second
> is to make a super cathode driven 4CX250B amplifier. I have considered
> giving it a slight bit of control grid signal, not much, in such a way
> that it is easily controlled to make some measurements.
>
Thanks for sharing this. I just learned something. I wasn't aware that the
super-cathode drive might be a good idea on a tetrode. From reading Tom's
stuff in the past, I got the impression that Bill Orr's design was a bad
idea for ANY tube.
www.w8ji.com/vhf_stability.htm
I have some 4CX250Bs here. Maybe I'll build one of those myself someday for
144 or 432.
> All, I have left of my 6AG7 amplifier is my homebrew heat sink.
>
You put a heat sink on the tube? I started to use a 6AG7 in an amp circuit
over 40 yrs ago, but never did.
73, Mike
www.w0btu.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|