Hi Joe,
I have used them this year to test a few 8874s and 3cx800's and found them
to be quick, reliable, and the results generally consistent with what I
already knew or was told about the tubes, and the tubes came back clean and
well protected.
I was a little concerned when I was told in an email not to worry about
gettering the tubes -which I did anyway first, as well as continuity and few
thousand volt hi pot test just to be sure I wasn't sending an obviously bad
tube in - but based on my experience would recco them.
YMMV of course.
73 Scott
In a message dated 6/10/2016 9:03:50 A.M. Central Daylight Time,
nss@mwt.net writes:
Greetings Everyone,
My first Official posting.
Is anyone familiar with this offer on E-Bay to test tubes?
http://www.ebay.com/itm/Power-Tube-Testing-Service-Low-Power-Eimac-Electron-
Tubes-8877-8874-4CX250B-/291362633865
Or anyone else that can test power tubes?
No sense building an amp around a tube, if you are not totally sure the
tube is good.
Joe WB9SBD
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|