Amps
[Top] [All Lists]

Re: [Amps] AL-80A - Won't tune on 160m.

To: "'Bill Coleman'" <aa4lr@arrl.net>, "'Amps Reflector'" <amps@contesting.com>
Subject: Re: [Amps] AL-80A - Won't tune on 160m.
From: "George Hall" <n2cg@verizon.net>
Date: Sun, 04 Sep 2016 22:07:56 +0000
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Greetings Bill and the group,

I have a late model AL-80A build in mid 1989 just a few months before MFJ 
bought Ameritron and soon after replaced the AL-80A with a total redesigned 
AL-80B which is still in current production with some change along the way.  
According to Carl KM1H On Nov. 28, 2015 QRZ.COM AMPS Forum the band switch 
wafer that usually burns out is the 160m contact solder terminal.  To prevent 
this from occurring a #8 brass flat washer is placed over the 160m terminal and 
soldered in place (see attached photo with yellow highlight and red circle area 
- sorry for the photo of a black and white picture ... that’s all I have and I 
don’t remember where I downloaded it from).

My AL-80A had this #8 brass flat washer installed as Carl said, but I have a 
feeling earlier production AL-80A models did not.

However you replace the burnt 160m band switch contact, if you AL-80A does not 
have this brass flat washer in place, then I strongly suggest you do so.

73, George  N2CG   
 

-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Bill Coleman
Sent: Saturday, September 03, 2016 12:11 AM
To: Amps Reflector
Subject: Re: [Amps] AL-80A - Won't tune on 160m.


> On Jun 22, 2016, at 6:56 PM, Bill Coleman <aa4lr@arrl.net> wrote:
> 
> I managed to fix my issues with the metering circuits on the AL-80A. However, 
> while it appears to work correctly on 80-10m, I cannot get the output network 
> circuit to resonate on 160m.
> 
> I hooked it up to a dummy load, fed about 35 watts, keyed and tune. Peak 
> output is achieved at maximum C for both Plate and Load, but it’s only maybe 
> 100 watts out, and the tuning is very broad. Nothing like 80m, which works 
> fine.
> 
> Any suggestions?

I finally got the AL-80A on the bench again and found that the switch contacts 
for the extra plate circuit capacitance are burnt away. Since I’ve never used 
the amp on 160m, this wasn’t me, but probably the previous owner.

So, this problem is at least identified. I’ll have to either replace the 
contacts, or the entire switch wafer.

Bill Coleman, AA4LR, PP-ASEL        Mail: aa4lr@arrl.net
Web: http://boringhamradiopart.blogspot.com
Quote: "Not within a thousand years will man ever fly!"
            -- Wilbur Wright, 1901

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>