Jim,
That's not exactly what I said, but exactly what I intended to do.
Steve
On 6/25/2017 7:41:PM, Jim Thomson wrote:
Date: Fri, 23 Jun 2017 21:38:05 -0400
From: Steve Bookout <steve@nr4m.com>
To: amps@contesting.com
Subject: Re: [Amps] issue with AL-1200 output
<Hello all,
Jim is right I didn't mention what band. I guess I was biased toward
it being the output relay.
It was on 15 meters so I would not expect there to be any padder caps there.
Have been getting ready for field day today, so didn't mess with it.
First thing I'll do when I open it up is to solder across the output relay.
73 de Steve, NR4M
## watch out soldering anything across the output relay. If a contact is
stuck, welded, bridged ,etc,
you dont want 1.5 kw back feeding towards the xcvr input relay contacts.
## U really just want to temp go from the load cap...to output connector....
bypassing the output portion of the
relay altogether.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|