I know how to cold test an anode circuit by connecting a resistor
between anode and grid using a resistor with the value of the design
plate RL. I presume that I can do the same cold test for the input by
using a resistor of the value of cathode Z in. Its a 3CX800A7 is
supposedly 54 ohms for my design parameters. I am assuming that if I
connect a resistor of this value between the cathode and grid I can do
exactly the same thing as for the anode?
Is this correct or did I miss something?
Regards
Conrad PA5Y
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|