Amps
[Top] [All Lists]

Re: [Amps] Stuck setscrews

To: "'Amps reflector'" <amps@contesting.com>
Subject: Re: [Amps] Stuck setscrews
From: "David Harmon" <k6xyz@sbcglobal.net>
Date: Fri, 8 Dec 2017 14:56:43 -0600
List-post: <mailto:amps@contesting.com>
Put the point of a hot soldering iron down in the hex hole to liquefy the
Loctite or whatever it is.


73

David Harmon
K6XYZ
Sperry, OK


-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Victor
Rosenthal 4X6GP
Sent: Friday, December 8, 2017 6:27 AM
To: Amps reflector <amps@contesting.com>
Subject: [Amps] Stuck setscrews

I have an older Palstar AT-Auto tuner. It uses stepper motors to turn a
rotary inductor and a capacitor. It works very well in my station (or it
did).

The motors are connected to the coil and capacitor with semi-flexible
insulated couplings that are made out of some kind of plastic strip. The
plastic on the one for the capacitor has disintegrated. I have a good
quality metal and ceramic coupling to replace it with, but I can't budge the
setscrews holding the old one. Allen wrenches twist to no effect.

The screws are held with some kind of glop. I don't think it is Loctite but
I don't know for sure. I put some penetrating oil on them and am waiting to
see if that works.

I suppose I could drill them out if needed, but that is a last resort
because I am afraid of damaging the motor or the capacitor. Any suggestions?

--
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>