These may be Bristol splined hex type wrenches. I have run across them in gear
over the years.Russ KW6T
From: Mark Beckwith <r-emails@n5ot.com>
To: amps@contesting.com
Sent: Sunday, March 4, 2018 7:35 AM
Subject: [Amps] Plate hardware for Eimac tubes
Hi - having some difficulty here swapping tubes around. Is there a standard
tool/hardware size for the plate caps and heat sinks on top of the Eimac
tubes (I'm working with 3-500s and 4-400s this evening trying to get an amp
working). It seems like it must be a Torx T5. Is that right? Is it
standard? Hex keys don't seem to work, and the set screw heads are so small
I really can't see them well enough to get after it without risking damaging
tool or part. (Also I don't have a Torx T5 and it just seems like that must
be it but I don't have one to try).
Help? Thanks.
73 - Mark N5OT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
| | Virus-free. www.avg.com |
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|