[Top] [All Lists]

[Amps] 8877 HF amp cathode wiring

To: <>
Subject: [Amps] 8877 HF amp cathode wiring
From: "Jim Thomson" <>
Date: Fri, 17 Aug 2018 14:27:01 -0700
List-post: <>
Helping a buddy with a HF  hb  8877  amp. 

It appears there is  2 ways to  wire the  cathode assy. 

What I suggested.. is   fil leads to  sec of fil xfmr.    CT of fil xfmr not 
.01 uf cap from each fil to chassis..right at the socket.   Drive applied to 
cathode terminal on socket..via  a coupling cap. 

Cathode goes to one end of a 28 uh inductor.  Other end of same inductor goes 
to series bias diodes.
Bottom end of series  diodes goes to resistor   used for cut off bias on RX.    
Shorted out on TX. 
Bottom end of cut off resistor  goes  to   the positive terminal of  BOTH  the 
plate and grid meters. 
Negative terminal of  plate meter  goes to the B-.    Negative of the grid 
meter  goes to chassis. 

Does this sound ok ?   This is one way it is done in orrs last handbook. 

2nd method is as follows.   Bifilar used on fil leads.   .01 uf caps  from cold 
sides of bifilar to chassis. 
Drive applied to cathode..via a coupling cap.  .01 uf  cap from hot side of 
each fil back to cathode. 
28 uh choke wired to cathode.  cold side of same 28 uh  choke  wired to  series 
bias diodes. 
Cold end of bias diodes to RX cut off resistor.  Cold end of cut off resistor  
wired to the positive terminal
of both plate and grid current meters.  Negative of grid meter to chassis.   
Negative of plate  current meter to B-. 
There is  no  grid over current protection in this amp..... only a fast 3 agc 
small  current value fuse between  negative term
of grid meter  to   chassis.   Some real  grid over current protection may be 
added at a later date.  

Right now, we used the 1st method.   ( amp has not been tested...yet).  On 
paper,  either will work.   The 1st method does not require a bifilar. 
And neither method requires the CT of the  fil xfmr.    B+  supply is being 
rebuilt.   But the RF  deck can be tested with the usual plate load
resistor temp wired from anode to chassis, and MFJ  on output side..and all vac 
 relays operated. 

Tuned input  will also be tested  with drive applied...   but shows flat swr, 
after tweaking..into a 50 ohm   dummy load. 
Bypass  SWR on RX is also flat. 

Jim   VE7RF  
Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>