[Top] [All Lists]

Re: [Amps] QRO 2500 MARK lll

To: Amps Amps <>
Subject: Re: [Amps] QRO 2500 MARK lll
From: John Bodine <>
Date: Sun, 17 Mar 2019 16:21:31 -0400
List-post: <>
Try one tube at a time. Probably just one tube went.

On Sun, Mar 17, 2019, 9:29 AM gudguyham--- via Amps <>

> Sounds like a bad tube
> Sent from AOL Mobile Mail
> Get the new AOL app:
>  On Saturday, March 16, 2019, Bob Gibson via Amps <
> > wrote:
> I have a problem that just came up with my QRO amp..First I blew a 1/2a
> fuse on the bias board..I replaced it turned it back on then a 1/2a fuse
> blew on the LV and bias board again but not the same fuse..Screen voltage
> is OK and HV is OK. When I hit with 10 watts the fault light comes on and
> kicks the amp off and I see the grid current meter go all the way over..I
> see no burnt parts or smell parts...could this be a grid short in one of
> the tubes? I have pulled the tubes and nothing looks bad below..I think I
> will send the tubes down and have them check just to make sure it is not a
> problem with one of them..Bob W5RG
> _______________________________________________
> Amps mailing list
> _______________________________________________
> Amps mailing list
Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>