Amps
[Top] [All Lists]

Re: [Amps] Henry 2K-4 Failure

To: amps@contesting.com
Subject: Re: [Amps] Henry 2K-4 Failure
From: Mark - N5OT <r-emails@n5ot.com>
Date: Wed, 18 Mar 2020 15:45:48 -0500
List-post: <mailto:amps@contesting.com>
Thanks ALL!

I'll swap in a different set of tubes to confirm or rule out that it's one of the tubes.  Then if it is a tube, I'll do them one at time to figure out which tube it is.

Thanks for all the great answers.  A bunch of "it's probably a tube" then a couple outlier answers for if it turns out to not be a tube :-)

73 - Mark N5OT


On 3/18/2020 10:33 AM, Mark - N5OT wrote:
Hello [Amps] Gurus,

I had a failure of my Henry 2K-4.  I am betting it is a well-known failure mode, and that multiple people on here, after hearing a description of what happened, will be able to tell me what happened.

I am operating a contest.  SSB.  I notice there is no output on my power meter.  I look at the amp.  The meters are not moving when I talk.  But the tubes are glowing orange quite nicely.  Like ... TOO nicely.

The tubes are glowing so bright orange - I know something is VERY wrong.  I wasn't transmitting.  I could not make it stop.  I pulled the TR relay control cable.  No change.  Nothing I tried got this situation to change.  I shut off the amp's power switch and let everything cool down (a very bad feeling to turn off both the glowing tubes and the blower too - ugh).

At that time, with zero drive, not in transmit mode, not key down, the meters read like this:

Plate current = 400ma
Grid current = pinned negative

I messed with the power switch and the breaker and the relay and the bandswitch and - honestly I was baffled and not being methodical at all - and after some "messing" the amp started working again.

Then a short time later it happened again, but since I was keeping a very close eye on it, I shut it off immediately.

Then it started working again.

Then finally it failed again and it has stayed failed.

So ... my guess is, youall having a very large amount of knowledge and experience, you can probably tell me which relay has failed or which capacitor or resistor became intermittent then failed. Or if it's a tube that shorted or something like that.

Thanks in advance.

Mark N5OT

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>