Date: Fri, 15 May 2020 14:12:57 -0500
From: Paul Kraemer <elespe@lisco.com>
To: amps@contesting.com
Subject: Re: [Amps] SB220 Meter blown...follow up hope
<That will certainly test the meter movement!? It will pin hard once that
<then you will know it is bad.
<NEVER TEST A METER MOVEMENT WITH A OHMMETER!
<Paul K0UYA
## Never had a problem so far..with my fluke 87 across meter
movements..and they were 0- 1 ma types, if I remember correctly.
I think this was with 87A manually switched to lower scales.
## I used to wire rvs connected diodes across both plate and also
grid meter.
These days I just wire the rvs diodes.. between B- and chassis. In
some cases
2 diodes are used in series... 4 in total.
In some cases, a resistor is wired in series with each rvs connected
diode...that was a
W6WRT trick..which works good.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|