Hi Tom,
Before you tear everything apart, pull the tubes and turn on the amp. If the
relay behaves correctly and you have normal signal strength received signals,
you most likely have a shorted 811A tube. This is a very common symptom.
73,
Dave, K2DP, St. Louis, MO
Sent from my iPad
> On Aug 8, 2020, at 3:57 PM, Tom Osborne Sr. <w7why1@gmail.com> wrote:
>
> Hi Again.
>
> My AL-811H antenna relay is acting up. When it goes back to receive
> sometimes it is not making contact and receive is way down. I thought I
> would take the case off and clean the contacts on the relay.
>
> To my surprise, the relays are not open frame where you can get at them.
>
> So - I guess the only solution would be to pull the board and unsolder the
> relays?? Not looking forward to having to do that 73
> Tom W7WHY
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|