Amps
[Top] [All Lists]

[Amps] Elecraft KPA500 and KPA1500 owers New Display Units

To: "amps@contesting.com" <amps@contesting.com>
Subject: [Amps] Elecraft KPA500 and KPA1500 owers New Display Units
From: Keith Ennis via Amps <amps@contesting.com>
Reply-to: Keith Ennis <nelasat@yahoo.com>
Date: Mon, 5 Oct 2020 13:09:19 +0000 (UTC)
List-post: <mailto:amps@contesting.com>
These DDUs allow you to install the amps away from the main operating position 
and still allow the 
viewing of the amps operating status.
 
The Digital Display Unit* for the Elecraft KPA500 allows you to monitor these 
crucial readings all at the same time.
 
A great way to help protect your investment
 
1. Power amplifier's heat sink temperature
2. Power amplifier's high voltage supply voltage
3. Power amplifier's current
4. Power amplifier's output power
5. SWR that the KPA500 sees at its output
PLUS:
Shows band KPA500 is operating on
Also if KPA500 is in standby or operate mode
 
Display Unit can be located at a more visible location
up to the RS232 limit from KPA500 unit
 
Easy to read 2 line display
No USB or serial cable to computer
No com port in Windows to manage
No computer needed
Plug and Play
Simply connect the SUPPLIED dc power cable (with inline on/off switch) to power 
supply and SUPPLIED DB9 PC data jumper cable to the KPA500's PC port
Retains all functions of the KPA500 front panel
All displayed info obtained directly from the KPA500
4" x 4" x 2"
  
The DDU will poll the KPA500 and display PA voltage and PA temperature during 
receive and transmit cycles. It will add watts, SWR and current during 
transmit. There is a built in hold time to keep the watts and SWR displayed for 
a short amount of time after unkeying.
  
The Display unit for the KPA1500:
 
Displays the same display as is on the KPA1500 Amplifier 
Change the display on the KPA1500 and the DDU changes
 
Display Unit can be located at a more visible location
 
Up to the RS232 limit from KPA1500 unit
 
Easy to read 2 line display
No USB or serial cable to computer
No com port in Windows to manage
No computer needed
Simply connect the SUPPLIED dc power cable (with inline on/off switch) from the 
DDU to power supply and SUPPLIED XCVR SERIAL data jumper cable to the KPA1500 
from the DDU
Retains all functions of the KPA1500 front panel
All displayed info obtained directly from the KPA1500
Only 4" x 4" x 2"
 
Note:
Please note that my DDU uses the XCVR SERIAL port when in use
 
Info:   www.kv5j.com
 
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>
  • [Amps] Elecraft KPA500 and KPA1500 owers New Display Units, Keith Ennis via Amps <=