[Top] [All Lists]

[Amps] Heath Parts and Pieces FS

To: Amps List <>
Subject: [Amps] Heath Parts and Pieces FS
From: "Ken, W8EK" <>
Date: Sat, 30 Jan 2021 12:10:29 -0500
List-post: <>

I have a variety of parts from various
Heath units available.

Hopefully by utilizing these, we will be able
to keep several more great Heathkits running.


I have a Heath SB-200 HF Amplifier that
apparently was started by a now silent
key, but was not finished. It is completely
unused, which means all parts are NEW.

Here is a list of the NEW parts
that are presently available:

Front panel

Tuning Variable Capacitor

Loading Variable Capacitor

Fan and motor

SWR sensitivity pot

Large aluminum chassis

Other small parts (such as resistors, capacitors,
etc.) are also available.

Meter, input coils, tank circuit, knobs, case
and power supply parts are gone.

These are NEW parts.
What do you need? Please let me know.


Parts for Heath SB-630 station console:

Many SB-630 parts are available.

Most of the internal parts are left, including
all of the "under chassis" parts.

The clock is available, and runs.

Knobs, front panel and outer case are gone, but
reflectometer assembly, transformer, switches,
etc. are still available.

Please let me know what you need.


Resistors for HF Linear Amps:

Have you replaced the filter caps or do you
have an error in the high voltage reading
in your linear amp?

Most amps used resistors that got too hot for
bleeders/equalizing near the filter caps. I
have some 120 K ohm, 3 watt, 1% resistors
that are really great for bleeder/equalizing
resistors in the capacitor string. 1% equalizes
much better. $0.75 each

Many amps used three 4.7 meg resistors
in series to meter high voltage. Almost all
of these resistors are out of tolerance today,
partially because of their age, but also
because their voltage rating was exceeded.

I have 4.7 Meg, 1% tolerance, 2 watt, and are
rated to handle the high voltage. This compares
to the original resistors furnished by Heath that
were 4.7 Meg, 5%, 1 watt and about 400 volts.

Buy a set of three for $3.


Heath HD-15 Phone Patch Parts:

This is the unit with the VU meter on
the left and 3 knobs that match the
SB series to the middle and right. Low
or high Z output to the transmitter.

Most internal parts are available.

The meter, outside cover, and knobs are gone.

What do you need?


ORIGINAL Heath manuals For Sale:

New manuals have been added, some
with no check marks, in new condition.

These are original manuals, for Heath
equipment, in very nice condition.
Schematic in the book.

GD-600 Photoelectric Light Switch, $4
HD-1234 Coaxial Switch, $3
HD-1481 Remote Coax Switch, $7
HD-4040 Terminal Node Controller, $8
HD-4040-2 TNC HF Header Kit, $2
HM-2102 VHF Wattmeter, $6
HN-31 Cantenna RF Dummy Load, $5
HP-23 B Pwr Supply, No check marks, new, $12
HW-2021, 2 meter HT, No check marks, $9
HW-2036, 2 meter transceiver, partial manual, $8
ID-4801 EPROM Programmer, No check marks, new, $10
IN-17 Decade Resistance Box, $4
PK-1 Scope Probe, $3
RS-1 Resistance Substitution Box, $5
SA-2040 Ant Tuner, No check marks, new, $20
SB-104 HF Transceiver, no check marks, new, $30
SB-200 HF linear amplifier, $20
SB-614 Station Monitor, No check marks, new, $15
SG-7 Signal Generator, $8

These are original Heath manuals only.


I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
Just too many to list here. Please e-mail your requests.

Prices do not include shipping from Florida.



Ken, W8EK

Ken Simpson
E-mail to or
Voice Phone (352) 732-8400



Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [Amps] Heath Parts and Pieces FS, Ken, W8EK <=