[Top] [All Lists]

Re: [Amps] [yccc] Acom2000a Heater Voltage Too Low 0.0v

To: <>, <>
Subject: Re: [Amps] [yccc] Acom2000a Heater Voltage Too Low 0.0v
From: gudguyham via Amps <>
Reply-to: gudguyham <>
Date: Wed, 24 Mar 2021 09:33:17 +0000 (UTC)
List-post: <>
Bob, is your amp in warranty still?  If so we have warranty status right here 
in Danbury, CT. or of course out of warranty work as well.  Your amp is 
obviously telling you that either the filament is missing entirely of perhaps 
there is no filament current being drawn.  This could be a wiring issue, 
perhaps a fuse issue or a transformer issue.  Lastly it could be that the tube 
filament opened up.  Naturally a course of logical troubleshooting must ensue 
on that amp to determine exactly what the problem is.  If you cannot imagine 
how to go about troubleshooting a problem of no filament voltage, it’s best to 
bring it to someone who knows.  If it’s in warranty you are covered if not it 
can still be fixed over here in Danbury.  Contact me at and 
I’ll get you in touch with the local authorized Acom repair.  Lou

Sent from the all new AOL app for iOS

On Tuesday, March 23, 2021, 10:48 PM, <> wrote:


When I turned on my ACOM2000A tonight I expected to hear the usual click 
and fan noise and then see the countdown starting from 145 seconds.  But 
that's not what happened.

Instead, I got the click and fan noise and after two seconds of 
countdown the fan shut off, standby was discontinued and the message 
"Heater Voltage Too Low 0.0v" was flashed on the RCU."

Does anyone know what may have caused this and how I can fix it?

Tnx & 73

Bob KQ2M
Amps mailing list

Amps mailing list
<Prev in Thread] Current Thread [Next in Thread>