When doing what I call a reverse SWR check,
Where you place resistors from the plate connection to ground to
simulate the Plate Load Impedance.
Then activate the T/R Relay.
And measure the SWR on the amp output.
What is the typical say 1.5 to 1 SWR bandwidth on the various bands?
I would assume on 80 is it far smaller than on 10.
But what is typical for a typical Amp like a Heath SB-220?
Joe WB9SBD
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|