Amps
[Top] [All Lists]

Re: [Amps] MLA-2500 Tube Conversion

To: "'Nidhog'" <robrk@nidhog.net>, "'Jay Sturtevant'" <k2ztdx@gmail.com>
Subject: Re: [Amps] MLA-2500 Tube Conversion
From: "N4zed" <n4zed@comcast.net>
Date: Sun, 10 Oct 2021 15:08:55 -0400
List-post: <mailto:amps@contesting.com>
Thanks Jay

Ken
N4zed

-----Original Message-----
From: Nidhog <robrk@nidhog.net> 
Sent: Sunday, October 10, 2021 2:06 PM
To: Jay Sturtevant <k2ztdx@gmail.com>
Cc: N4zed <n4zed@comcast.net>; Amplifier Reflector <Amps@contesting.com>
Subject: Re: [Amps] MLA-2500 Tube Conversion

Even if you have the correct output filament transformer, check the primary.
I have a few from the olden days of 115 line voltage.

4CX250’s want 6.000. 
My 30L1 wants 115/230, not today’s 120/240 +.
There are Eimac papers that suggest running a percent or two below listed 
number and cranking it up  in a few years when power falls off.
Do a search.

Sent from my iPad

> On Oct 10, 2021, at 12:58, Jay Sturtevant <k2ztdx@gmail.com> wrote:
> 
> You might want to check with an expert on this forum to make sure 
> your filament supply is correct. I run a pair of 3cx800A7s and the 
> designer/builder stressed correct filament voltage,  if I remember 
> correctly.
> 
> Jay, K2ZT



-- 
This email has been checked for viruses by AVG.
https://www.avg.com

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>