Amps
[Top] [All Lists]

Re: [Amps] LK800C Help

To: Tom Hellem <tom.hellem@gmail.com>, Amps group <Amps@contesting.com>
Subject: Re: [Amps] LK800C Help
From: gudguyham--- via Amps <amps@contesting.com>
Reply-to: "gudguyham@aol.com" <gudguyham@aol.com>
Date: Tue, 7 Dec 2021 00:42:53 +0000 (UTC)
List-post: <mailto:amps@contesting.com>
Your amp probably has an ALO board so look a a schematic of maybe an Lk500 C 
that has ALO


Sent from the all new AOL app for iOS


On Monday, December 6, 2021, 6:51 PM, Tom Hellem <tom.hellem@gmail.com> wrote:

I have an Amp Supply LK800C TNY that's had a couple previous owners.
Just finished putting in a vac variable tune cap with turns counter, for
which I had to remove and strip the front panel. I noted carefully all the
wires that needed to be hooked back up, but I fear I may have made one
mistake: the Xmit/bypass switch now does not work. So I might have gotten a
couple wires crossed, but the schematic in my possession may not be the
correct one because it shows only a couple wires connected to the switch,
and on my amp there are 5 wires connected to the 3 terminals on this switch.

Can anybody help me out with a schematic? Or is anyone familiar with the
wiring of the switch?
I am reluctant to just start moving wires around.

The amp works, but I can't put it into bypass, it's always in transmit mode.

73
Tom
K0SN
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>