G'day all.
I've been helping my friend John, VK6JX, who is not a subscriber to this
group, with the building af a "1 x GS35B 2m Lazy Builders PA" as
described at https://www.qsl.net/yu1aw/VHF_PA/PA%20for%20lazy%20build.htm
The intended use is for digital EME.
The build and the testing has been quite successful but for one problem.
It is as per the specs in the link above, except he has added the
ability to adjust the output loading, which the original design does not
have.
The very robust power supply gives 3.2kV DC. The cooling blower supplies
heaps of CFM to keep everything cool as a cucumber. Filament volts is
steady at 12.6V at all times.
The amplifier tunes smoothly and perfectly and puts out around 1000 to
1100 Watts but only at around 45% efficiency. We were hoping for better
than that but maybe that's how life is.
Now here's the problem.
With 100W of drive and 1000W plus out. Plate current is around 800mA and
grid current at around 300mA.
The amp holds up for around 20 seconds and then the power spirals down
quite rapidly and it is accompainied by a corresponding rapid increase
in plate current.
Let go of the key and let her cool for a minute and try again. Once
again, after 20 seconds or so, the symptoms occur.
As the power output goes down, we can follow it with the tune control
and raise it a bit for a second or two but then she crashes as before.
We have tried a different NOS tube with exactly the same results.
Something is taking off.
We are at a bit of a loss as to what is actually happening so we don't
know what the fix might be.
All suggestions will be gretaly appreciated and vigorously investigated.
Thanks and 73, Alek, VK6APK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|