The front panel meters are sandwiched between the control board and the
front panel with spacers in-between.
Power supply is a full wave bridge, with a massive Hypersil, Dahl
transformer ~ 65lbs Ht ~3440 vdc at my location, not sure on the current
rating , it did not flinch when operating. (~15.5X9X8) .
Any of the Commander Amps that I have seen and or own have the glued in
meter. All of the Palstar I have seen are bolted.
*/AJ___ VE3HJ
/*
On 1/22/24 06:58, Rob Atkinson wrote:
I hope Palstar's changes included mounting the front panel meters with
nuts and bolts. The Command amp we looked at had the meters GLUED to
the front panel, something I have never seen before or since in a
commercially manufactured RF equipment. Also, the power supply was a
voltage doubler. This must have been one of Pat Stein's early
efforts.
73
Rob
K5UJ
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
Knowledge is Power and Power is Knowledge.___AJ___1967
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|