If you're worried about turn on, one old trick I've used is to use an external
"Soft start" per se. Using two 120 volt 100 watt light bulbs in sockets each
one in series with one 220 volt leg. This will of course limit current flow to
I=P/E. The problem of course is finding the right incandescent bulbs these
days! But you get the idea. De wa3jpy
-------- Original message --------From: Larry Carpenter <aa4vi@outlook.com>
Date: 10/9/24 5:45 PM (GMT-05:00) To: "amps@Contesting.com"
<amps@contesting.com> Subject: [Amps] Harbach Heathkit SB-220 Soft Start Update
I have had some time to investigate my Harbach Soft Start failure and found
some very unusual results. First while the amp was in an idle state I heard and
arc saw smoke from the top and side of amp and it powered off. I have checked
all the rectifier diodes, filter capacitors and bleeder resistors and found
them all in tolerance and no diodes or caps shorted or open. The Harbach board
itself is completely failed. By this I mean both ceramic 20 ohm resistors open
and the two 48 vdc spdt relays have open coils, one trace on the Harbach board
between the relay and 240 line is burned open and the resistor in series
between the two relay coils is open. The bridge rectifier that supplies voltage
for the Harbach relays also seems to test open. I am wondering if I have a
shorted 3-500Z or something else. Neither circuit breaker operated and power
switch is still functions when tested with an ohm meter. I see about 2.5 ohms
of resistance looking at the primary of the power transformer. I a m a little
hesitant to apply power even with the tubes out. Has anyone else seen such a
catastrophic failure of a Harbach Soft Start module? Thanks,
AA4VI_______________________________________________Amps mailing
listAmps@contesting.comhttp://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|