Re: [Amps] RF making it's way into a digital control box.

[donroden@hiwaay.net]

Your RF level at the relay is already close to 3ma. Add an interface to 
lower the resistance.
Don W4DNR

On 2025-01-07 10:56 am, Ron W4BIN wrote:

> On 1/7/25 11:17 AM, Lukasz wrote:
>
> > The trick is to make the input to the problem relays to require
> > POWER to
> > activate them.  Feed a high current to those channels and drop the 
> > input
> > resistor divider down to the hundreds of Ωs.
> >
> > Ron W4BIN
> >
> > This will be difficult . I can pull at most 4mA at 3.3V on the control 
> > lines out of the uC board. That is not a lot of power.... I'm already 
> > at over half of that, so realistically ... I can't pull more than 3mA 
> > with a bit of safety factor.
> How about using the input power to the 3.3 Volt regulator, 6, 10  or
> 12 Volts?
>
> > If anyone has one ideas please share.
> Ron W4BIN
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps