Antennaware
[Top] [All Lists]

RE: [Antennaware] Question

To: <k8ze@charter.net>, <antennaware@contesting.com>
Subject: RE: [Antennaware] Question
From: "kc3m" <kc3m@suscom.net>
Date: Wed, 15 Oct 2003 19:21:37 -0400
List-post: <mailto:antennaware@contesting.com>
Hi Mike

There are a few ways I like to do it.

Use several layers of a high quality rubber electrical tape as a base
and then cover that with several layers of a high quality plastic/vinyl
electrical tape.

Use an electrical Insulation Putty such as 3M Scotchfill and some wraps
a high quality plastic/vinyl tape.  Properly applied, the Insulation
putty provides an excellent air and water seal.  If you suspect you
might disassemble the connectors you may want to tape - putty - tape, as
the electrical putty directly applied to the connectors will make
disasembly very hard and... sticks to everything.

73 -  Jack KC3M

-----Original Message-----
From: antennaware-bounces@contesting.com
[mailto:antennaware-bounces@contesting.com] On Behalf Of Mike Switzer
Sent: Wednesday, October 15, 2003 5:02 PM
To: antennaware@contesting.com
Subject: [Antennaware] Question


I am getting ready to put up my new tower and antennas (been 20 years
since I have had a real antenna).  I have used in the past a "filler" to
keep moisture out of my connectors.  I forget what I used can anyone let
me know what is advisable.  By the way I have used this on some and not
used it on others and never noticed any difference.  I worked for
Motorola years ago and with every installation we got a little packet of
"grease" to put in the connector.  I don't remember who the manufacturer
was. 

 

mike

 

K8ZE

k8ze@charter.net

 

_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware


_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware

<Prev in Thread] Current Thread [Next in Thread>