[Antennaware] feedline modeling

[Paul Decker <kg7hf@comcast.net>]

Hi Group, 



Using EZ-NEC, is it reasonable to model an open wire feed line, for example a 
600 ohm ladder line using two parallel wire segments shorted at each end by two 
other wire segments, one end being the source, the other being the load? 



I know I can add a transmission line and change the impedance, but what about 
if I'm modeling the "special" transformation properties of specific lengths of 
transmission lines?  



If not, how is this done?    



thanks, 
Paul (KG7HF)
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware