Hello to all of my friends,
It is my final project stage of monster rotary tower on my Contest site =
on Obosnik hill, before we start with production. It has to be primary =
low bands tower, but because tower is rotary, of course it will be load =
with standard vertical stacks for 20/15/10m bands. And for 2m too!
I attach drawing of tower.
Four duobanders ( 2 el./80 and 3 el./40m ) on boom about 14m, full size =
has to be on heights 80/60/40/20m. For 80m idea is to be Yagi with =
director, because on this geographical location we do not care about F/B =
ratio.=20
Every suggestion in next three hot weeks are welcome. I did not decide =
what kind of CW/SSB switching on 80m antenna will be used and I am still =
searching for the most efficiency solutions? I am sure that most of you =
will help with ideas and advices about resolving many electrical and =
mechanical problems.
The most important facts are:
a.. All antennas will be produce from galvanized steel=20
b.. Weight is less important than wind area.
Existing towers are:
1. Self-supporting tower 48m with 3el./80m, 7el./10m, 5/5/5/5/5/5/7el. =
for 15m
2. 40 m GP for 160m with: 4el./40m, stacks for 20/10m
I can put new Low Bands tower anywhere on the west.
On pictures you can see existing antennas and towers.
73
YT6A
You can forward this e-mail to anyone who can help!!
[sri - no attachments on the cq-contest reflector -- list admin]
--
CQ-Contest on WWW: http://lists.contesting.com/_cq-contest/
Administrative requests: cq-contest-REQUEST@contesting.com
|