Not an expert in the field of STUBS, however use ur calculator and figure a
1/4 wave length multiply by the cable volicity factor. Tipically .77 for
RG-8 RG-11 RG-58.
You can get close with this method, If your really picky an antenna
analyzer can be used to fine tune it.
Leave the end of the 1/4 wave X .77 stub open on the end. I don't
think it would be possiable to make one to stop interferance between 20
SSB and 20 CW.
80/40 40/20 will however work.
Rex
----- Original Message -----
From: "Gregg Seidl" <k9kl@direcway.com>
To: <CQ-Contest@contesting.com>
Sent: Thursday, June 10, 2004 14:03
Subject: [CQ-Contest] stubs
> There was a mention of making/using coax stubs to help in a m/s and m/m
> enviroment.How do you make those,I would like to make some for our FD
effort
> and just to have around? Gregg K9KL
>
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|