Hi Jim,
>From the 419A manual, the units are SINK DRIVE.
>From the BCD10 manual, the unit can either SINK or SOURCE depending on how you
>wire the board.
73 de Al, KE1FO
----- Original Message -----
From: Tack Kumagai
Sent: 6/24/2004 1:06:30 AM
To: MM0BQI@blueyonder.co.uk;cq-contest@contesting.com
Subject: Re: [CQ-Contest] ICE 419 Connection Diagram
> Hi Jim
>
> According to my memory, BCD10 has only "SINK DRIVE" output but
> ICE419 must be driven by "SOURCE DRIVE".
> So you need to have SOURCE DRIVER between BCD10/ICE419.
> I once tried to change 419 source drive to sink drive but no way.
> You'll be able to assemble source driver less than $10us on small
> breadboard. (I prepared but not completed)
>
> In message "[CQ-Contest] ICE 419 Connection Diagram"
> on 04/06/23, "Jim Martin - MM0BQI" <MM0BQI@blueyonder.co.uk> writes:
> :
> : Can someone point me in the direction of a wiring diagram for the ICE419 BPF
> : on the web?
> : I am connecting it to the MP via a W9XT BCD10 band decoder and need the
> : pinouts.
> :
> : I intend to use the band output socket on the MP and power the band decoder
> : from here also. Are there any issues with this or is this standard?
> : Thanks
> : Jim MM0BQI
> ---------
> Tack Kumagai JE1CKA/KH0AM
> JE1CKA <je1cka@jarl.com>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|