The one question you didn't answer is :
"Why doesn't DX Summit take 100% of the spots from the traditional
cluster system ?"
73,
Steve, N2IC
On 02/28/2017 06:36 PM, Lee Sawkins wrote:
I would like to try and clear up a few things about the spotting network.
DX Summit currently takes 77% of its spots from the traditional cluster system.
Only 23% of DX Summits spots actually originate on DX Summit. These spots are
identified by the -@ at the end of the spotters call. The traditional spotting
network has all the DX Summit originated spots. These spots are identified as
originating on the OH8X node. In other words, the traditional cluster system
and DX Summit can both have exactly the same spots. Some DX Clusters,
especially DX Spider nodes block Summit spots by dropping OH8X spots. OH8X
spots are sent to the traditional cluster system by my software, which monitors
DX Summit.
Some wonder why DX Summit doesn't carry skimmer spots. During the ARRL CW
contest there were approximately 4,700,000 RBN(skimmer) spots in 48 hours. This
is an average spot rate of almost 100K spots per hour for the whole contest. At
peak times the rate can exceed 100 spots per second. For some users this would
probably be too fast to watch, although N6MJ could probably do it.
Individual skimmers repeat spots every 10 minutes if the station is still there and
actively CQing. During contests the skimmers get out of sync with each other. This means
that the spots of individual stations are not spotted every 10 minutes, but rather almost
every minute. My own CC Cluster software filters these spots so they do get sent to users
any more frequently than 3 minutes. This means that programs like N1MM and probably
others will almost always show these spots as "new" if the station is still
using the frequency.
During SSB contests I see myself spotted less than once an hour. During the
CQ160 SSB I was operating VE7NY and we were spotted 13 times in 20 hours.
During the CQ160 CW I saw VE7NY spotted by 35 different skimmers in a couple of
minutes. The skimmer spots are an absolute game changer for those of us who are
not in the north east of NA. CW and RTTY contesting have become much more fun
for those of us who aren't rare DX or don't have big signals into Europe.
Connect to a CC Cluster and turn on skimmer spots by "set/skimmer". Then enter the command "set/own". When you call CQ,
you will see EVERY skimmer spot for your own call. You will know if and where you are being spotted. If you are not being spotted, you may
need to change your CQ to include "CQ" or "TEST". Simply signing your call or sending "FOC VE7CC VE7CC FOC"
for the FOC contest may result in zero spots as the RBN is not looking for that identifier. "CQ VE7CC VE7CC FOC" will magically
turn on the skimmer spots.
Lee VE7CC
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|