K is fine why KW? K even works for that other mode SSB. Which will be
a real gem in a few weeks with these condx!
W0MU
On 2/19/2018 12:53 PM, Barry wrote:
The power is supposed to be a number, like K, so I logged 0 :-)
Barry W2UP
On 2/19/2018 9:53 AM, Jim wrote:
So do you log "T" or 0 (zero)? Or does it matter for the contest
sponsor?
BTW, Obscure cut numbers are a pain but that is another discussion.
Jim KS1J
-----Original Message-----
From: CQ-Contest [mailto:cq-contest-bounces@contesting.com] On Behalf
Of Jamie WW3S
Sent: Monday, February 19, 2018 01:03
To: John W; John Geiger
Cc: CQ Contest
Subject: Re: [CQ-Contest] What's with the power = 0 watts exchange?
I worked three, think they were all kp4....0, 00 and ,000.....they
were all doing pretty good for no power !!!!!! I just logged what
they sent zero , double and triple zero.....
On Feb 18, 2018 7:44 PM, John Geiger <af5cc2@gmail.com> wrote:
I worked 2 of those 0 and 00 stations also. Both were from KP4. Missed
the
10 meter opening today, did hear V51YJ yesterday on 15 but didn't
get him.
Nice to hear 15 open to other hemispheres at this point in the solar
cycle.
On Sun, Feb 18, 2018 at 12:58 PM, John W <xnewyorka@hotmail.com> wrote:
I'm playing a little in the ARRL DX contest and I've noticed
something new that I don't recall from previous years. Several DX
stations have sent their power as zero watts. I've received 5NN T,
5NN TT, and 5NN TTT
so far.
(For some reason, nobody is sending something more precise like 0.0
(would that be TRT?)
What is the reason for this? I must have missed the memo.
At least one of the stations was in Puerto Rico. So I was wondering
if his zero meant that he has no commercial power at his station.
Maybe I'm reading into it too much?
And one South American sent "LP" for his power. So does that mean
he is using a generator that runs on Liquid Propane? 😉
The rules at http://www.arrl.org/arrl-dx say:
4.2 DX stations send signal report and power (number or abbreviation
indicating approximate transmitter output power).
Where I come from, transmitter power is measured in units called
WATTS.
So I would expect the exchange to be either a number, or an
abbreviation for a number, for example using 'cut' numbers. "LP"
is not exactly that.
But I get it - it probably means 100 watts, or at least "no
amplifier".
But what does TTT mean? That must mean "approximately 0.499 watts
or less". Yet the guy was 10 dB over S9, so I doubt that.
Ahh well, got to do something to keep it interesting when condx are
in the toilet.
Hope everybody caught the brief but glorious 10m opening this
afternoon.
P40W was 15 dB over S9 in NNJ for more than 10 minutes!
73,
John
W2ID
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|