Carol,
I use a Rigblaster Advantage with my K3. Here are my settings in WJST-X:
CAT Control :
Serial Port COM4
Baud Rate 38400
Data Bits 8
Stop Bits 1
Handshake NONE
PTT Method RTS
Transmit Audio Source Front Mic
Mode USB
Split Operation NONE
The mic cable from the Rigblaster is plugged into to MIC connector in
front of the radio . Have you checked to see if your speaker/mic is
using the input/outputs from the Rigblaster and not your computer
speaker/mic? Also check to make sure the volume for the Rigblaster isn't
muted. My master volume is about half way up. Are you seeing any green
on the left bottom side of the WJST-X program? If not you aren't getting
any audio from your radio.
Hope this helps.
Jeff
On 12/21/2019 03:57 PM, Carol Richards wrote:
Hello all,
I am using a Rig Blaster advantage with WSJT-X. It was working fine
until I made some mods in the shack. Now it doesn't decode anything.
Is anyone out there using a rig blaster advantage with WSJT-X and can
help me trouble shoot my problem? I know my settings are good in the
program so it must be a cable problem. I did run a time sync program
to no avail.
Thanks,
Carol
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|