There is a raft of interrelated parameters that can be set in the
KPA-1500 firmware on a per-band basis, relating to the allowable SWR.
The KPA-1500 manual is of limited help on these, and much more
explanation of how they interact, in particular, would be welcome. But
from my experience, when my KPA-1500 faults, it is almost always with
the indication that a limit on reflected power has been exceeded.
Training of the ATU is absolutely required, particularly on 40 and below.
73, Pete N4ZR
Check out the Reverse Beacon Network
at <http://reversebeacon.net>, now
spotting RTTY activity worldwide.
For spots, please use your favorite
"retail" DX cluster.
On 3/5/2020 10:50 AM, Dan wrote:
I agree with Jim's comment. My KPA 1500 does not fold back until I
reach close to 3 to 1. I rarely use the tuner and my CC 2L 40 will
cover the whole band without using a tuner. I would imagine that
certain combinations of impedance and reactance might have an effect
on the fold back. The other elephant in the room is SWR being read on
meters is not always what it seems. My Daiwa, KPA 1500 and K3 (running
bare foot so not into amp input) can all have different SWR readings
on the same frequency.
Dan W8CAR
-----Original Message----- From: Alan M. Eshleman
Sent: Wednesday, March 4, 2020 12:48 PM
To: k9yc@arrl.net
Cc: cq-contest
Subject: Re: [CQ-Contest] Elecraft KPA 1500 vs.OM 2000A
that's been my experience with my KPA1500...
----- Original Message -----
From: Jim Brown <k9yc@audiosystemsgroup.com>
To: cq-contest <cq-contest@contesting.com>
Sent: Tue, 03 Mar 2020 17:57:05 -0800 (PST)
Subject: Re: [CQ-Contest] Elecraft KPA 1500 vs.OM 2000A
On 3/3/2020 10:13 AM, Edward Sawyer wrote:
super SWR sensitive doesn’t sound like good characteristics for an amp.
I have NOT experienced SWR sensitivity with reasonable antennas that the
KPA1500's built-in tuner can't handle. I suspect someone having this
problem has not RTFM, which describes how to train the tuner for each
antenna for each band, or has not taken the time to do it.
The KPA1500 can memorize settings for three different antennas for each
band for each of the two antenna ports.
And I DO get pretty close to 1.5kW on 6M.
73, Jim K9YC
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|