Hi gang,
Are you a CT interface guru???
Here is the scoop. I am trying to configure CT v9 running a PK-232 (RTTY),
PK-88 (packet) and also an Icom radio control interface.
They all work fine with RTTY by WF1B contest software. (RTTY TNC, Packet
TNC, Icom radio control)
-----
Here is the setup....
Com1 -> Mouse, IRQ4, 3F8h, 9600 baud, None
Com2 -> Icom, IRQ3, 2F8h, 9600 baud, XON/XOFF (handshaking)
Com3 -> PK-232, IRQ5, 3E8h, 9600 baud, None
Com4 -> PK-88, IRQ10, 2E8h, 9600 baud, None
The PK-232 has all DB-9 pins active to the serial port, Com3
The PK-88 is usings only DB-25 pins 2, 3, 7 to the serial port, Com4
-----
CT will not recognize the PK-88 for packet spots. (Yes, I chose a contest
class that allows TNC spots)
CT will not recognize the Icom radio control. (Yes, I did load the COMTSR
files)
AEA PC-Pakratt software will not recognize the PK-88 in it's 'normal' mode,
but will in dumb terminal mode.
HyperTerm will operate the PK-88 (it is a dumb terminal program).
CT should act as a dumb terminal so I can't understand why it won't see the
PK-88.
No clue as to why it won't see the Icom control.
I think that maybe I need more signals than just DB-25 pins 2, 3, and 7, but
the combinations that I have tried screw up the currently working software.
Can anyone help the serially challenged?
de Rick
Rick Mintz, W1TY
Rochester (NY) DX Association
Rmintz@frontiernet.net
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|