> Does this pertain?
> Mike N2MG
>
>
> Ken said a few weeks ago:
>
> I have found that running EMM386 sometimes croaks CT on some machines.
> This
> is an interaction between the new DOS extender I started using at
> version
> 9.3X. Edit your config.sys and remove EMM386.
>
> - Ken
>
> ***************************
> Ken Wolff K1EA
> K1EA@contesting.com
> ***************************
>
>
>
>
> When I launch CT939 I get the following message:
>
> DOS/16M error [23] no memory for VCPI page table
>
> typeing MEM at the DOS prompt shows
>
> Conv 603K
> Upper 31K
> High 0K
> Extended 0K
> Extended in XMS 0k
> EMS 432k
>
> BEFORE I run CT939, I ran CT910a with no problems. After exiting
> CT910a,
> I get from MEM:
>
> Conv 603K
> Upper 31K
> High 0K
> Extended 0K
> Extended in XMS 2994K
> EMS 432K
>
> These are the same numbers I get afater a fresh boot in DOS. I use
> DR-DOS on a 386SX with 5 meg total ram.
>
> Terry Zivney, N4TZ/9
> 00tlzivney@bsuvc.bsu.edu
>
>
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|