Marcel
What version of CT? 9.xx --- fill in the xx part.
Does it work with other logging software? Is the baud rate correct?
Try select IC-756 and changing the hex address of the radio to match (I think
the IC-756 is hex 50).
We used the 9.39 for WPX (or was it 9.38) on the IC-756 and it worked fine.
Mike VA3MW
At 01:06 PM 5/26/99 , Va3mg@aol.com wrote:
>Hello all CT Users. I have been unable to ust my CT ver 9.xxx with my new
>IC-775DSP since I bought it. The radio will not read anything from the CT
>program nor will the CT program register anything from the radio. It will
>only log from 20 mtrs and will not read the freq, mode,etc. If I do Alt F1
>to change bands it will revert back to 20 mtrs to log the entry. It will not
>show the freq but only 14.000. This will happen on all bands. If I remove
>the radio from the set up it will log O.K. on the desired bands. This will
>not allow me to use any of the CT program featurs.
>Has anyone else figured out how to get around the problem??????
>I sent a few emails to K1EA and nothing back yet. I understand it is a Icom
>problem only????
>
>Ken do you have any time frame on getting a fix for this Icom problem???
>
>Regards and pls advise.
>
>Marcel Gervais
>VA3MG
=================================================
Mike Walker VA3MW
Corbeil Contest Club
http://www.qrz.com/wrad/directory.cgi?VA3MW
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|