Good news! I now have the radios physically connected to the PCs and all is
OK .... the lesson is that CT defaults to 20m if it cannot find the radio
----- Original Message -----
From: Brian & Lynn Miller <BRIANMILLER@xtra.co.nz>
Sent: Monday, 27 September 1999 23:22
Subject: [ct-user] WPX BAND CHANGE PROBLEM
> I have just encountered the band change problem mentioned in a previous
> by Bob KQ2M.
> Our configuration is CT 9.40 configured for WPX MM category, K1TTT TSR
> Ethernet network and FT1000MP radios
> Everything appears to work fine except that CT logs all calls against 20m
> regardless of which band is actually in use. This problem is only evident
> AFTER selecting the FT1000MP radio in setup ..... if the radio is not
> selected then there is no problem.
> I have also tried version 9.39 and it exhibits the same problem.
> Has anyone managed to find a solution or workaround for the problem? Note
> that I do not have the radios to the computers yet - does connecting the
> radios help? Maybe version 9.42 will address this issue?
> Brian Miller ZL1AZE
> Registered Electrical Engineer
> 67 Hornsey Road
> New Zealand
> Tel +64-4-387-9081
> E-mail: firstname.lastname@example.org
> Submissions: email@example.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.k1ea.com/
> Questions: firstname.lastname@example.org
Administrative requests: ct-user-REQUEST@contesting.com