You most likely have the interrupt set different in the comtsr from
what the port actually is.
Check to see what the port setup is, then start up the COMTSR like
this:
COMTSR1 -I15
In this case the IRQ would be 15.
Robert E. Naumann
N5NJ / V26O
N5NJ@arrl.net
www.qsl.net/n5nj
Plano, TX USA
ex KR2J, V26RN, W6V, WA2OVE
----- Original Message -----
From: "The Tolberts" <jtolbert@gremlan.org>
To: <ct-user@contesting.com>
Sent: Saturday, March 24, 2001 02:35
Subject: [ct-user] one way kenwodd freq control
>
> Forgot to mention other programs ( N1MM, EQF, Win-EQF) all read the
850s
> freq; only CT seems to not read it. I noticed on k1ea.com something
about a
> "auto information" setting? Is that in the Kenwood menus? I can't
locate the
> manual....
>
> 73 Jamie WW3S
>
>
> --
> WWW: http://www.k1ea.com/
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> Problems: owner-ct-user@contesting.com
>
>
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|