Yep...
Just select something similar (ie: built around the same time) and change
the Hex address in the IC-706 to match. Most of the commands are the same
by the same manufacturer.
I have used the IC-706, and just called it a IC-756 (hex 50).
I set CT to IC-756, and set the hex address in the IC-706 to a value of
x'50'. You can use IC-756 Pro, and then use an address of x'5C'.
Most of the functions will work. It will fall apart above 30mhz though.
Mike
At 02:41 AM 6/18/01 +0000, n5po@juno.com wrote:
>I do not see the IC-706 listed in the radios supported
>by CT. Can CT be used to control the IC-706?? How?
>
>
>Thanks
>
>Lee, N5PO
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|