Bob
You can 'fake' out your radio to be a IC-756PRO by changing the hex address
of the radio to 50. You will find that most commands should work.
Set CT to use a IC-756PRO.
I haven't tested this, but I have managed to do it with multiple Kenwood and
Icom units.
Mike VA3MW
----- Original Message -----
From: "Robert Morris" <rsmorris@worldnet.att.net>
To: <ct-user@contesting.com>
Sent: Friday, March 15, 2002 11:18 PM
Subject: [ct-user] Questions
> Greetings,
>
> Have 2 questions...
>
> 1. Is there a way to have packet on the network feeding any/all computers,
> but not send QSO data from one or 2 computers to the rest? What I want to
do
> is have the packet in each position, but have 2 rigs/computers on 10M.
They
> only send QSO data between them. Have 2 rigs/computer on 15M. They only
> send QSO data between them and so on..
>
> 2. Is there an emulation for an IC746 in CT??
>
> Thanks in advance
> 73/Bob
> W4MYA
>
>
>
> _______________________________________________
> ct-user mailing list
> ct-user@contesting.com
> ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
>
|