Many thanks to Arie, PA3AAM,
-----Original Message-----
From: ct-user-admin@contesting.com
[mailto:ct-user-admin@contesting.com]On Behalf Of Arie Kleingeld en
Marian van Boheemen
Sent: 13 October 2002 08:47
To: CT-User@contesting.com
Subject: Re: [ct-user] Ct and CQWW question / help
Best way is to keep the country window open.
If you hit the spacebar it will show the zone.
Enter ´tranfers´ the zone to the log.
73,
Arie, PA3AAM, Bob N5NJ, and Jim N4OJ for advice on this point.
I consider my recollection of how it works now fully corrected!
See you all in the contest. We hope to be putting out a FB signal on LF
bands also- will have sea site, and high support available!
Dave
G3NKC (op at MD4K)
----- Original Message -----
From: Jim Brannigan <jbrannig@optonline.net>
To: David L Sharred <G3NKC@thersgb.net>; Ct-User@Contesting.Com
<ct-user@contesting.com>
Sent: Saturday, October 12, 2002 11:00 PM
Subject: Re: [ct-user] Ct and CQWW question / help
> Yes, that is how it worked. There is a table of prefixes and zones. Do
you
> have it loaded in the same directory?
>
> Jim
>
>
> > BlankI recall that, in the past, when working in CQWW mode, that when
you
> > enetered a call (ie G3NKC) that CT would automatically load the zone
(ir
> > zone 14) in the call out window, and it was generally up to the user to
> > change this
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> CT-User-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
_______________________________________________
CT-User mailing list
CT-User@contesting.com
CT-User-request@contesting.com Subject=unsubscribe to unsubscribe
http://lists.contesting.com/mailman/listinfo/ct-user
|