At 05:16 AM 12/11/02 +0000, KØHB wrote:
>I had a similar problem with an Icom 761. I cured it by reducing the interface
>speed to 4800 baud.
I too have found that you can't run faster than 4800 in CT with my 756Pro.
>By the way(1), you don't need to set the speed when invoking the COMTSR. Just
>set the speed in the CT comm setup screen.
>
>By the way(2), you should contact Joe Spear and get upgraded to Hyperlog 4.14
>--
>much, much, much improved over the years (I've been running Hyperlog since
>1988.)
By the way(3), you should upgrade to CT 9.83, available on the website.
|