I had 5 DX contacts show up as state multipliers. For DX, DX gets typed into
the state field. One was S51CK which had S5 in the state field. I don't
think I typed S5 in the state field. One was PA3ARM which if I remember
correctly, I did not type PA in the state field. I actually did work a PA on
both SSB and CW and both counted as multipliers. PA3ARM should have been DX.
Usually if I make a mistake on a call or state, I can correct it. I could not
get rid of these. I am not absolutely certain that I did not make typos in the
state field but I make a lot to attempts to get them corrected. I think this
is a bug. I ought to be able to make corrections. I also suspect there are
some automagic insertions of multipliers.
73, Bob
|