Hello, i think that for CT DOS u can use DX2-486 with 8 Mb RAM... that is
enough!
Here for CTwin i am using P2 - celeron 400MHz/96Mb RAM on win98. Its a
little bit slow but works,
CW keying on LPT and 2xCOM ports for 2x TS440s, radio control works faster
when u use TS850 radio setup in the
program. Also switching both radios on LPT with S56A SO2R (smallest
interface on world) and telnet enabled.
73
----- Original Message -----
From: "Serge Vaskovsky US4LGW" <us4lgw@ukrpost.net>
To: <ct-User@contesting.com>
Sent: Wednesday, December 17, 2003 11:18 AM
Subject: Re: [ct-user] CT 9.92.001 Slow down
>
> Well, Gentlemen
> The final results of our discussions are :
> - upgrade computer to use CT 9.92.xxx with its all features
> (DOS or Win, it doesn't matter)to (min) P-II 400 MHz, 128 Mb RAM;
> - use an older releases of CT 9, which can even run on DX2-66MHz
> 16 Mb RAM.
>
> Did I missed something ?
>
> --
> Best regards,
> Serge US4LGW mailto:us4lgw@ukrpost.net
>
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
> CT on the web: http://www.k1ea.com/
>
>
> __________ NOD32 1.568 (20031202) Information __________
>
> This message was checked by NOD32 Antivirus System.
> http://www.nod32.com
>
>
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|