Bill,
Do you have a subnet calculator? That will do all the work for you
Dan Metcalf
Wireless Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com
-----Original Message-----
From: Bill Fisher [mailto:fisher@akorn.net]
Sent: Friday, May 24, 2002 10:19 AM
To: karlnet@WISPNotes.com
Subject: RE: [Karlnet] More routing questions
Yes. I understand. But I can't seem to break it in to smallish chunks.
Bill
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Bob Rohr
> Sent: Friday, May 24, 2002 3:24 AM
> To: karlnet@WISPNotes.com
> Subject: Re: [Karlnet] More routing questions
>
>
> Have you tried to breakdown the class c addresses into different
> subnets? Example:
>
> 10.10.10.1 subnet mask of 255.255.255.252 on one interface, this gives
> you 2 usable hosts. then subnet the rest of the ips into the groups that
> you want. Example: 10.10.10.4 255.255.255.192 this creates another
> network 62 usable host which you should be able to pass thru another
> interface without causing ip conflicts. With every subnet you
> essentially are creating networks inside of the class c network that
> you should be able to route thru different interfaces..
>
> Bill Fisher wrote:
>
> >
> >If I have an entire class-c passed to a router, can I not assign
> the router
> >an IP address of say 10.10.10.1 / 30 and then add an indirect route of
> >10.10.10.32 / 128 through another interface?
> >
> >I seem to only be able to break the Class-C in two chucks.
> >
> >bill
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|