Ok guys... I have a question..
What is the proper config for a user that you want to run DHCP & Outgoing
NAT.
Public IP: 207.193.79.100
Subnet: 255.255.255.0
Gateway: 207.193.79.254
Internal Radio IP: 192.168.100.254
Private IP: 192.168.100.100
Subnet: 255.255.255.0
Gateway: 192.168.100.254
Now the real question is... If you want to enable Outgoing & Incoming Nat, &
DHCP do you have to Enable Bridging to get that to work? We have about 19
locations that have Outgoing/Incoming & DHCP enabled and DON'T have Bridging
or IP Routing Enabled...
Is that the way it should work?? Because the last 2 customers we ran into
some problems..
On one of the installs we had to Enable Bridging and give the PC a public IP
to get it to work.
The one yesterday we had to Enable Bridging, Enable Outgoing NAT & DHCP. And
everything started working...
Im not sure if anyone else has seen this.
I guess I would like to hear from Doug or Kevin from Karlnet about this.....
What is the proper way to setup the CPE.
We use RG-1000 or RG-1100 with SR-4000's installed.
We use Outgoing NAT & DHCP so that the user doesn't have to setup a IP or
know anything about it.
Anyway... has anyone else seen this?
Or how do you setup your RGs to do this??
What is the correct way??
Nate McLain
Chisholm Trail Networks LLC
nate@ctrail.net
http://www.ctrail.net
580-401-6656
405-880-2795
"Bringing broadband Internet Access to over
20 Communities in North Central Oklahoma!!"
|