check the version number of the bin file you are using. Version 4.0 didn't
have support for it. 4.02 does have support.
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Nate McLain
> Sent: Monday, September 16, 2002 7:18 PM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] WavePoint - II E ???
>
>
> Has anyone else had any problems flashing the WP-II E??
> I just tried to flash 2 of these and they both act the same way....
>
> You can read them with the configev program.
> Get your license, Open config file, select the .bin file.
> Scan for the radio. Change the IP of the WPIIE to a IP in my subnet.
> Upload the software.
>
> Let the AP reboot and then your hosed...
> You can never scan it and you never get another network
> connection to it...
>
> I tried doing a forced reload as described in the pdf file and I
> can't ever
> get it into base boot mode... The power led always goes to green. And no
> network connection.
>
> Can someone shed some light on this problem?
>
> TIA
>
> Nate
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|